The Ribbons will be worn 1/8-inch above the top of the left pocket, centered on the pocket, and parallel to the floor. The regimental crest will be worn 1/8-inch above the top of the right pocket and centered. On the male ASU jacket, the nametag will be worn on the right pocket flap, centered between the top of the pocket and the top of the button, centered on the flap and parallel to the ground. The "U.S." or branch insignia will be canted parallel to the inside edge of the lapel on the ASU coat.Īfter completing AIT or OSUT, male Soldiers will wear military occupational specialty branch insignia on their left collar. The bottom of the insignia disk will be 1-inch above the notch where the collar meets the lapel, centered between the seam and the outside edge of the collar. The Army white shirt may be worn with or without the ASU coat, which is known as the Class B uniform.Į-4s (Specialists) and below must always wear their grade insignia on the collars of the white shirt.Ĭorporals and above must wear shoulder board grade insignia on the white shirt.ĭuring initial entry training, males will wear the "U.S." insignia disk on both collars. The Improved Outer Tactical Vest (GEN II) Video Donning Doffing: Information of Army Uniforms is located in Army Regulation 670-1 The Desert Sand Riggers belt will be worn with the ACU (OCP). Soldier may sew on the U.S Army tape, name tape, rank and all authorized badges, as an option. Grade insignia is attached to Velcro area provided in center of the jacket flap. Army identification insignia attached to Velcro. Soldiers wear subdued (cloth) last name and U.S. Grade insignia: Army Combat Uniform / Operational Camouflage Pattern (OCP) Names of 11 letters or more will be printed in 1/2-inch high Franklin Gothic Extra Condensed. Names of 10 letters or less will be printed in 3/4-inch high Franklin Gothic Condensed. It consists of black letters on a 1-inch wide by 4-1/2 inch long (or to the edges of the pocket flap) strip of cloth. Worn immediately above and parallel to the top edge of the right chest pocket of all field and work uniform coats and shirts. The background can be either olive green or the universal camouflage pattern. This insignia consists of black, 3/4-inch high block letters on a 1-inch wide by 4-1/2 inch long (or to the edges of the pocket flap) strip. Worn immediately above and parallel to the top edge of the left chest pocket. Unit-of-choice trainees are authorized to wear, from the start of training, the insignia of the specific unit for which they enlisted. Subdued shoulder sleeve insignia will be worn on all field and work uniforms.Īrmy National Guard (ARNG) and United States Army Reserve (USAR) trainees are authorized to wear the insignia of their parent ARNG or USAR organization from the start of training. Wear this insignia centered on the left sleeve. Soldiers in both BCT and AIT who are in one of the following categories may wear organizational shoulder sleeve insignia. Heels of boots should be replaced after wear of 7/16 of an inch or more.Įach Soldier is responsible for having the correct insignia properly placed on their uniform, as follows: Stuff paper in the toes and let boots dry in a warm, dry place.ĭo not put boots in the hot sun or next to a strong source of heat. Wipe insides dry with a clean cloth and remove all soapsuds from the outside. Scrape dirt or mud from boots and wash with just a little water and soap. They should have a chance to air out between uses, so you should wear one pair one day and another pair the next. New boots should fit properly when you receive them.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |